3/22/2023 0 Comments Irrigation switchbar![]() The grease added to the rubber ring may improve the sealing.ģ The one-way valve at the lower end of the cylinder is aged or embedded with garbage, and the water leakage is not tight. This requires unscrewing the cylinder and pulling out the piston combination to observe (there is some grease in the piston combination). There is no screwing here and air leaks.Ģ The aprons in the piston combination are worn or have rubbish, and the air is shut off. The pot head and the pot body are often unscrewed and added with water. Water can't be sprayed.ġ Tighten the sealing joints at 3 places. ![]() Lifting up and down, pressing the handle feels light, no power, no pressure inside the pot. The second case of watering can failure and repair If the inside of the tube is clogged, you can pull out the soft tube and clean it with a thin wire. The rotating water flow can be formed at the time (of course, the water flow is small through the spray cap)Īfter the hole is not rotated, one of the two channels is blocked, and the sprayed water mist is not round.Ĥ Unscrew the pot head and see if the filter hole at the lower end of the thin soft tube is clogged. In addition to seeing the half of the small hole of the spray cap, there is no waste, but there are also two carved passages on the nozzle. The wire is cleaned up a few times.ģ The board is switched, the sprayed water mist is not round and unilateral, and there is less on the other side. When the spray cap has been unscrewed, look at the side of the copper tube from the end of the copper tube. Normally, 2 water columns should be sprayed evenly.Ģ Rotate the copper tube again. Then the board is turned on and off a few times. If there is garbage, it will be unpleasant or not unilateral. The small hole of the spray cap is very small. The main thing is to see if there are some small passages that are blocked.ġ Unscrew the nozzle cap and see if there is any garbage jam in the small hole of the spray cap. The first case of the spray can malfunction and repair is unsatisfactory, and the sprayed water mist is not round and unilateral, but there is pressure inside the kettle. ![]() The following is a method of repairing the watering can for you to edit it, I hope to help you. After a long period of use, it is often difficult to use the fault. Everyone knows that the nozzle cap is tight and loose, which can adjust the diameter of the jetted water column and the amount of water. The watering can is generally used by everyone. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |